18
2023_001
2 Push the power button. The ICE MAKING indicator
light on the control panel comes on.
Note! In case the product stops for shortage of water or
power failure, the restart will be delayed for 3 minutes.
3 Open the lid and scoop out the finished ice.
Note! The ICE FULL indicator comes on when the ice
tray is full. Empty the ice tray and the product will restart
automatically.
Note! The ADD WATER indicator comes on when the tank
is empty. Fill the tank and push the power button to restart
the product.
3.4 To drain the tank
● Open the drain plug underneath the product to drain the
tank from water.
4 Maintenance
Warning! Always disconnect the product before you
do any maintenance on it.
4.1 To clean the product
● Drain the tank after each use.
● Clean the product after each use.
● Clean the inside and outside the product with a damp
cloth and a solution of water and vinegar.
● Clean the filter at the bottom of the water tank regularly.
5 Storage
● Drain the tank before you store the product.
● Clean the product before you store it.
● Store the product in a dry and frost-free place protected
from direct sunlight.
● Store the product with the lid open to avoid mold.
6 Disposal
6.1 To discard the product
● Make sure that you follow local regulations when you
discard the product. Do not burn the product.
● The product gets hot when in use.
● Do not use the product near open flames or other
sources of heat.
● Do not use any accessories other than those
recommended by the manufacturer.
● Always connect the product to a correctly earthed power
outlet.
● Do not place the product directly in front of a power
outlet.
● Only use the product on a stable surface.
● Do not tilt the product.
● Always disconnect the product when not in use or before
you do any maintenance on the product.
● Do not cover or put any strain on the power cord.
● Do not pour liquid on or immerse the product in liquid.
● Do not run the product at shorter intervals than 5
minutes. Risk of compressor damage.
3 Operation
3.1 To do before you operate the
product the first time
1 Remove all packaging on the product.
2 Place the product on a stable surface for at least 2
hours with the lid open.
Note! The ice produced for the first 3 cycles of operation
may be small and irregular.
3.2 To fill the tank
1 Open the lid and remove the ice tray from the tank.
2 Fill the tank with water to the maximum mark.
Caution! Do not fill over the maximum mark.
Caution! Do not fill the tank with purified water. Risk
of water sensor malfunction.
Note! Always use fresh water in the product.
3 Place the ice tray in the tank and close the lid.
3.3 To operate the product
1 Connect the product to a power outlet.
To Next Page
Loading...