GB
20
A
Check each time you use
the equipment
Inspect the equipment each time
before you use it. Do not use the
equipment if safety devices (switch
handle, safety covers) and/or if
the cutting device is damaged or
worn. Never disable safety devices.
Check the work area before
starting work. Remove any foreign
bodies present (e.g. stones,
branches or bones). Check for
foreign bodies whilst working.
11. Instructions for correct use, safety instructions
Fault Possible Cause Remedy
Motor overhaul at specialist
workshop required.
Cylinders, pistons and bearing
of crankshaft have seized.
No motor oil in crankcase.
Motor starts for a short time then
suddenly stops with a loud bang.
Clean spark plug and/or
fill the fuel tank.
Spark plug defective or
fuel tank empty.
Press the primer several times
(see Putting your Lawnmower into
Operation).
Tecumseh
Primer was not operated when
starting the motor.
No fuel, fuel tank empty.
Set the choke lever to choke.
(see Putting your Lawnmower into
Operation).
Briggs & Stratton
Choke lever not set to choke when
the motor is cold.
Press start button.Start button not pressed in.Motor does not start.
Readjust the belt tension.Driving belt slips.
Contact specialist workshop/
service centre.
Driving belt defective.The blade shaft does not rotate.
Retighten the bearing screws.
Have damaged parts replaced
by the specialised workshop/
service station.
Blade shaft damaged
(out-of-balance),
fixture at the bearings loose.
Erratic running,
the implement vibrates strongly.
Tighten bolts. Contact specialist
workshop/service centre.
The motor screws, its fixture or
the blade shafts are loose.
Unusual noises,
the implement rattles.
General
Faults usually occur if the unit has
not been handled, cared for or
maintained properly. The following
table contains the most common
faults and remedies to eliminate
these faults. If you have any other
problems, please contact your
nearest service centre authorised
by the manufacturer, or your near-
est authorised specialist dealer.
A
Caution! Repairs that
require specialist knowledge
must only be carried out by an
authorised specialist.
A
Caution! For safety reasons,
only use original spare
parts supplied by the manufacturer
or parts that have been authorised
by the manufacturer.
We expressly point out that in
accordance with product liability
laws, we are not liable for any
damage caused by our units if this
damage is due to improper repair
or if parts exchanged are not our
original parts or parts approved by
us, and if the repairs were not car-
ried out at service centre authorised
by the manufacturer or by an author-
ised specialist. The same applies to
spare parts and accessories.
10. Troubleshooting
To Next Page
Loading...
