30 1018959-B
==================================================================================================
MAINTENANCE AND SPECIFICATIONS
Maximum Speed .................... 5 mph
Tank Capacity ...................... 15 gal
Maximum Pump Pressure ............. 40 psi
Fuse (Blade Type) ................. 10 amp
SPECIFICATIONSMAINTENANCE TIPS
• The key to years of trouble-free
service is to keep your sprayer
clean and dry.
• Never allow material to remain in tank for extended
periods of time.
• Should rust develop, sand lightly and then paint area
with enamel.
• Periodically check all fasteners for tightness.
• Rinse / dry inside and outside of sprayer after each use.
CLEAN AFTER EACH USE
IMPORTANT: Always empty and clean the sprayer
immediately after each use. Failure to do so may cause
the chemicals to dry or thicken in the lines, clogging the
pump and other components.
TO PROPERLY CLEAN THE SPRAY SYSTEM:
1. Drive vehicle to a designated cleaning area
(a driveway or easy-to-clean surface).
2. Use three separate rinses.
3. Use a minimum of 2 gallons (7.6 L) for each rinse.
4. Use the cleaners and neutralizers as recommended by
the chemical manufacturers.
5. Use pure clean water (no cleaners or neutralizers) for the
last rinse.
CHEMICAL DISPOSAL
IMPROPER CHEMICAL
WASTE DISPOSAL CAN POLLUTE
THE ENVIRONMENT AND CAUSE HEALTH ISSUES.
Follow the disposal directions on the chemical manufacturer’s
label. Dispose of chemicals and containers in accordance to
local / state / federal laws.
English Manual
To Next Page
Loading...