Brinsea Chick Safe eco - User Manual

1
 Important! Install the ChickSafe Eco and attach the door BEFORE installing batteries.
Failure to observe this may cause incorrect operation and possible damage. (See page 3).
 The ChickSafe is supplied pre-set to be attached to a FULLY OPEN DOOR. Failure to
observe this will cause incorrect operation and possible damage. (See page 3).
Please read these instructions carefully before setting up your ChickSafe Eco to achieve best results and keep these
instructions safe for future reference.
To register your new Brinsea product and qualify for your free 3 year warranty please visit www.brinsea.com within
30 days of purchase and follow the link on the Brinsea home page. The serial number may be found on the box
and inside the battery compartment. Sign up for the Brinsea newsletter to receive the latest news and information.
 Warning - Risk of injury! Keep fingers clear of moving door and cord. Motor may start without warning.
 Ensure the maximum door weight of 8lbs (4kg) is not exceeded as this will cause damage to the motor
and invalidate the warranty! Note that wooden doors are heavier when wet.
 The maximum door lifting height is 15” (400mm). Do not exceed this as operation will be incorrect and
the cord may become detached.
 Check the sliding door to make sure it runs smoothly and reliably both upwards and downwards. The
ChickSafe uses gravity alone to close the door.
 To mount the ChickSafe further away from the door, an additional length of cord may be attached. For
helpful information see our ChickSafe ‘Frequently Asked Questions’ page at www.brinsea.com
 This appliance can be used by children aged from 8 years and above and persons with reduced physical,
sensory or mental capabilities or lack of experience and knowledge if they have been given supervision
or instruction concerning use of the appliance in a safe way and understand the hazards involved.
Children shall not play with the appliance. Cleaning and user maintenance shall not be made by children
without supervision.
Installation and
Operating Instructions
D
A
A
2
Tools needed for installation:
- Screwdriver (cross head PZ1)
- Drill with a 1/8” (3mm) diameter
drill bit, or bradawl
- Tape measure
Caution! - Please Note:
• Use only alkaline AA batteries
• Observe correct polarity to
prevent leakage or risk of fire
• Do not mix old and new
batteries
• Do not use re-chargeable
batteries
• Do not use a 9 volt battery
• Remove the batteries if you do
not intend to use the ChickSafe
Eco for a long period.
1
1/8” (3mm)
Raise the sliding door to its fully
open position.
Support the door in that
position.
Once fitted, the ChickSafe will
always open the door to this
height. Make sure it is correct.
4 3/4”
121mm
6 1/2 “ 170mm
Mark two hole positions 4 ¾”
(121mm) apart and approximately
6 ½” (170mm) above the top of the
sliding door.
Make sure they are level and evenly
spaced above the centre of the door.
Make the holes with a 1/8” (3.0mm)
drill bit or bradawl.
CS010 US Issue 01

Summary

Important Installation and Safety Warnings

Pre-Installation Steps

Attach door BEFORE installing batteries. Attach to a fully open door. Read instructions carefully.

Operational Safety and Limits

Keep fingers clear of moving parts. Max door weight 8lbs (4kg). Max lifting height 15" (400mm).

Installation Tools

Screwdriver (PZ1), 1/8" (3mm) drill bit or bradawl, tape measure.

Battery Precautions

Use alkaline AA batteries only. Observe polarity. Do not mix old/new or use rechargeables.

Step-by-Step Installation Guide

Mounting the ChickSafe

Mark and drill mounting holes. Hang unit on screws, ensuring it's flat and secure.

Attaching the Door Cord

Fix a ring to the door. Tie the ChickSafe cord to the ring, ensuring it is taut.

Installing Batteries and Cover

Insert batteries correctly, connect the holder, and fit the battery cover.

Initial Operation Check

Verify the door opens/closes with daylight. Check operation carefully for the first few days.

Operation and Maintenance

LED Status Indicators

Understand LED flashes for door status (open/closed) and battery levels.

Closing Light Level Adjustment

Adjust sensitivity for door closing at dusk using a precision screwdriver.

Cleaning Instructions

Disconnect battery holder. Wipe surfaces with a damp cloth and mild detergent.

System Reset Procedure

Reset the system if batteries were connected before installation or cord detached.

Product Specifications and Contact

Product Dimensions

Height 5.9" (150mm), Width 5.9" (150mm), Depth 3.0" (75mm), Weight 13oz (375g).

Company Information

Contact details for Brinsea Products Inc., including phone, fax, email, and website.

Brinsea Chick Safe eco Specifications

General

Brand	Brinsea
Model	Chick Safe eco
Category	Farm Equipment
Language	English