8
2� Install the Faucet
IMPORTANT: If your sink does not have a second faucet hole, please contact a licensed professional to
create one. Do NOT attempt to drill a faucet hole yourself as this may damage the sink.
A� Install the faucet body (E) with
base plate (1) and washer (2) over
the hole in the sink.
B� From underneath the sink, attach
the faucet (E) to the sink using the
lock washer(3). Securely tighten
to ensure the faucetis secured in
place on the sink.
C� From underneath the sink, slide
the quick connector (4) over
the bottom of the faucet (E) and
secure in place using the clips (5).
IMPORTANT: Connect the faucet
tube (C) to the
quickconnector (4).
3� Make the Connections
A� Connect the two tubes to the engine (A).
Operation
Startup and Flushing of Water
Flush the filter in the engine (A) upon first use and each time you change the filter.
1� Open the feed water adapter (B).
2� Flush the system by opening the faucet handle until the stored water is completely emptied and the flow is
reduced to a trickle (about 1-5 minutes).
4
5
E
C
12
E
3
4
Ca
A
C
To Next Page
Loading...
Need help?
General
