Caring for your Brio Beardscape | 15
black tab on the blade assembly and tuck that into the mouth of the
trimmer. Snap the blade into place. Do not line up the black plastic
feet with the metal prongs on the inside of the trimmer – this will
cause it to jam. Simply tuck the blade assembly into the mouth of
the trimmer and snap the blade into place.
Use the micro-adjust lever to check the alignment and make sure
the blade is properly in place. This takes a little practice, but don’t
worry, it gets easier.
If you need a new blade or assistance with removing your blade
contact Brio at support@briopg.com.
To Next Page
Loading...