Brita On tap - Filter Cartridge Maintenance; Cartridge Replacement Indicators; Recommended Cartridge Change Interval; Filter Cartridge Replacement Procedure

6 ENGLISH
Green light: The BRITA On Tap water filter is working.
Yellow light: 90% of the filter capacity has been used.
Remember to buy a new replacement
filter cartridge.
Red light: The filter cartridge needs to be changed.
BRITA recommends that you change the filter cartridge
after 1200 litres of water has been filtered. Irrespective of
the filtered volume, the cartridge should be changed after 4
months of use. The red light comes on if the water quantity
or time period has been exceeded.
When the red light in the top cap starts to blink during
filtering the cartridge should be changed. Proceed as
follows:
J
I
B
7
Step 1:
The filter cartridge is attached to the base of the housing
(B). Screw the exhausted filter cartridge (I) to the left.
Unscrew it and pull it downwards and out of the housing.
The housing may still contain water, which will now leak
out. The exhausted filter cartridge can be disposed of with
normal domestic waste.
F
5
The symbols on the diverter are designed to assist you in
selecting the required position:
Filtered water Unfiltered water
To prevent damage to the diverter, choose the required
position before turning on the tap.
Step 2:
If the BRITA On Tap water filter is new, the filter cartridge
may still contain materials residue. This is harmless to
health and does not influence the performance of your
water filter. Run water through the filter for approximately
1 minute before using the water.
Please repeat this process with every new filter cartridge.
The water may briefly become darker in colour until fine
particles are eliminated. You may use this water for your
plants or discard it.
!
If the BRITA On Tap water filter system has not been
used for more than 24 hours, allow water to pass for
30 to 60 seconds before using the filtered water
6. Changing the filter cartridge
To ensure optimal performance, one should change the
filter cartridge on a regular basis. The electronic cartridge
change indicator (G) in the top cap (H) tells one when to
change the filter cartridge.
H
G
6
The three lights on the top cap of the On Tap housing are
only activated in the filtering position. They indicate the
following:
6. Changing the filter cartridge
5. Initial operation / 6. Changing the filter cartridge
1017032-00-ELA_OnTap_GA_Asia.indb 6 17.12.18 09:22