C
On the left side of the BRITA On Tap water lter system
there is a battery slot, which can be opened with a coin.
Before rst use, please remove the sticker from the
battery and place the battery back into the battery slot.
Press the reset button and the display countdown will
start to work.
•
Remove the attachment nut from the water lter body.
Screw the adapter onto the tap through the attachment
nut. Tighten the attachment nut securely to the water
lter body - the installation is completed.
Remove the attachment nut from the water lter body. Place the type C
adapter onto the water lter body and turn it about half a turn, attaching it loosely to the water lter body. Push the water lter
system rmly against the tap and tighten the screws of the adapter evenly. Tighten the attachment nut securely to the water
lter body - the installation is complete.
and you get
showered un ltered water i.e. to rinse vegetables.
for un ltered water in a straight beam
i.e. for washing hands or lling large water containers.
If the BRITA On Tap is new, the lter
cartridge may still contain material residue. This is
harmless to health and does not affect the perfor-
mance of your water lter. Run water through the lter
for 1 to 2 minutes to remove any residue. Please
repeat this process with every new lter cartridge. You
may use this water for your plants or it can be
discarded. If the BRITA On Tap has not been used for
more than 24 hours, allow water to pass for 30 to 60
seconds before using the ltered water.
•
Open the housing by rotating the cap anticlockwise.
Insert the new lter cartridge and close the system by
rotating the cap clockwise until it locks.
The BRITA On Tap comes with 5 different adapters
Choose the correct adapter for your tap (A / B/ C)
to be used for
drinking, washing fruit and vegetables and for cooking.
4
1037413-00-TOR_OnTap_GA.indb 4 19.03.19 16:37
To Next Page
Loading...
