21
HOW TO INSTALL
INSTALLING INTO A VEHICLE WITH SEATBELT.
(REARWARD FACING)
A. Position restraint rearward facing in the chosen seating
position in the car where a child restraint anchor fitting
is installed.
The stabilising bar need not be in contact with the
vehicle seatback but must be extended in position and
latched.
Some vehicle seat fabrics (particularly velours) may
be damaged by a child restraint used continuously. We
recommend the use of a seat protector or thick towel to
keep the vehicle seat in good condition.
B. Undo the buckle and place buckle tongues in the Buckle
Tongue Holders on each side of the cover.
C. Remove baby insert (if fitted). Lift the centre panel flap
and comfort pad from the inner seat.
BABY USE REARWARD FACING
To Next Page
Loading...
