Locate the LATCH anchors in 1
your vehicle.
Ensure harness height is *
adjusted to fit your child.
Rotate the positioning block to 2
the front and place the child
seat on the vehicle seat.
Verify that the LATCH strap is
3
not twisted and firmly press
the LATCH connectors onto
their adjacent LATCH anchors
to attach.
Push the child seat into the
4
vehicle seat and pull the end
of the LATCH strap through
the belt slot to secure.
The child seat is secure when it *
cannot be moved front-to-back
or side-to-side more than 1 in.
(2.5 cm) at the belt path. If the
child seat is not secure, repeat
the installation procedure or
use a different seating location.
Firmly press the Versa-Tether5
®
hook to the vehicle tether
anchor to attach. Remove all
slack from the tether webbing.
Use the elastic strap to contain
6
extra webbing.
Checklist
Check that positioning block is rotated to the front. 9
Check all connections and verify that child seat is secure. 9
The child seat is secure when it cannot be moved front-to-*
back or side-to-side more than 1 in. (2.5 cm) at the belt path.
If the child seat is not secure, repeat the installation procedure
or use a different seating location.
Ensure any excess Versa-Tether 9
®
webbing is stored in elastic
band. Always ensure any excess webbing is contained within
your vehicle.
<1 in.
Check Versa-T e ther
®
(Top T e ther) attachment
Check that Versa-T e ther
®
(Top T e ther) webbing is
stored in elastic band
Check LATCH
connector attachments
Check that the
Positioning Block is
rotated to the front
Check that there is
LESS than 1 in. (2.5 cm)
of movement (front to back
or side to side) at the belt path
To Next Page
Loading...
