Nest the harness straps by 9
inserting the right strap loop
into the left strap loop.
Remove the harness yoke
8
from storage on the belt shield
(a), then remove the belt
shield (b).
Turn and slide the retainer of
5
each harness strap through
the harness slot.
Ensure that the icon on the *
chest clip faces out.
Slide each retainer back into 6
place on the child seat shell.
Booster to Harness Mode
To replace the harness and
buckle:
Move the harness adjuster to
1
the highest position (a), then
move the head restraint to the
lowest position (b).
Ensure that harness slots in *
the cover, head restraint and
harness adjuster are aligned.
Replace the locking screw 2
to lock the head restraint
adjuster.
Turn and slide the retainer of
3
the buckle strap through the
buckle slot.
Choose the slot that is closest *
to, but not under your child.
Slide the retainer back into 4
place to hold it against the
child seat shell. Verify that the
strap is not twisted, and that
the button faces out.
Locking
Screw storage
Insert the harness straps 7
through the slots in the cover,
shell, and harness adjuster to
the back of the child seat.
Switching Between ModesSwitching Between Modes
To Next Page
Loading...
