54 55
Firmly press the Versa-Tether5
®
hook to the vehicle tether
anchor to attach. Remove all
slack from the tether webbing.
Use the elastic strap to contain
6
extra webbing.
Always ensure any excess *
webbing is contained within
your vehicle
Use the vehicle’s lap-shoulder 7
belt to secure your child.
Lap-Shoulder Belt
Ensure that the positioning
1
block is rotated to the back.
Place the child seat on the
2
vehicle seat and use the
vehicle’s lap-shoulder belt to
secure your child.
Positioning the Child Seat: Booster Mode
WARNING!
Never route the vehicle belt over the child when using this •
child seat in harness mode.
Adjust the belts provided with this child seat so they •
fit snugly around your child. A snug strap should not
allow any slack. It lies in a relatively straight line without
sagging. It does not press on the child’s flesh or push the
child’s body into an unnatural position.
The HUGS™ chest pads must be used at all times.•
Adjust the harness to fit the clothes the child is wearing. •
Remove bulky coats and/or jackets before putting the
child in the child seat.
Verify that the child seat is secure and the harness is •
properly adjusted around the child each time the child
seat is used.
Harness Mode
Before you begin:
Always check the seat area for debris and remove it to prevent
interference with the harness adjuster mechanism.
Positioning
Block
Securing Your Child
To Next Page
Loading...
