Replace the screw to lock the 7
head restraint adjuster.
Insert the harness straps
8
through the slots in the cover,
shell, and harness adjuster to
the back of the child seat.
Pull the head restraint cover
5
over the head restraint shell,
and reattach the elastic bands.
Be careful not to damage the *
energy-absorbing foam.
Move the harness adjuster to 6
the highest position (a), then
move the head restraint to the
lowest position (b).
Ensure that harness slots in *
the cover, head restraint and
harness adjuster are aligned.
Replacing the Cover
Fit the cover around the head
1
restraint.
Be careful not to damage the *
energy-absorbing foam.
Fit the bottom of the cover 2
over the lower part of the child
seat shell, then pull the elastic
loops over the hook on the
bottom of the child seat shell.
Pull the harness straps, buckle
3
tongues, HUGS™ chest pads,
and chest clip through the
appropriate holes in the cover.
Push the cover under the
4
lower belt guides.
Care and MaintenanceCare and Maintenance
To Next Page
Loading...
