Using the Chest Clip
Remove the Versa-Tether from the 1
storage clip.
Loosen the tether and place over
2
the child seat back.
Tilt the tether adjuster tab and pull
3
to fully extend the tether.
Locate the tether hook on the
4
strap.
Attach the tether hook to a
5
designated anchor point.
Tighten the tether.
6
NOTE: Anchor point locations in vehicles vary. Consult your vehicle owner’s manual to
help identify the anchor location.
IMPORTANT: Ensure any excess Versa-Tether
®
webbing is contained within your
vehicle.
Opening the chest clip. 1
IMPORTANT:
The correct height for
the chest clip is at the middle of the
chest at armpit level.
Using the Recline Block
IMPORTANT: Set the recline block position BEFORE installing into your
vehicle.
Booster Position
1 Harness Position2
NOTE:
The default position of the recline block is booster position. You
must unhook the Versa-Tether from the storage clip (if connected) before
moving the recline block.
Fastening the chest clip
2
To Attach the Versa-Tether:
Child Seat features OverviewChild Seat features Overview
Recline
block
To Next Page
Loading...
