12
www.house.co.uk
Central Heating
The temperature is factory set to the minimum 38
O
C, but
can be adjusted to a maximum of 82
O
C as required, refer to
diagram 4.
Use '+' and '-' buttons to adjust.
EcoStatus (if activated)
The EcoStatus function will provide you with energy
consumption information on the display, see diagram 5.
This will clearly show how your heating requirements affect
your energy consumption and therefore where savings
could be made. The display shows daily consumption in
kWh units and also a daily high or low trend indication
based on the previous weeks consumption.
Should you require this function, please ask your installer
to activate.
NOTE: The clock will need to be set as described on page
14.
Fault Finding
The LCD will display a ashing 'F' and code number, press
the reset button on the control panel.
If a fault persists, indicated by a ashing 'F' and code
number, contact your installer/service provider or British
Gas Service, using the telephone number on the inside
front cover of this booklet.
The boiler will not work without an electrical supply and
normal operation of the boiler should resume when the
electrical supply is restored.
Boiler Operation - User Controls
Diagram 4
1. Press the '+' or '-' once,
the current temperature
will be displayed flashing
2. Press the '+' or '-' to
increase or decrease
the temperature. The
temperature setting will
automatically save after
5 seconds.
14620
To Next Page
