13.3 Add-on Refrigerative Air-Conditioning on Classic Heaters
Add-on refrigerative air-conditioning can be used with Brivis Classic heaters, but must be controlled through a
Brivis Programmable Thermostat (see diagram left).
14. Commissioning and Control Settings
All Brivis heaters have been factory tested, but should be commissioned and adjusted in accordance with the
following instructions to ensure efficient and optimal heating performance.
Remember:
• Switch the mains power OFF before touching any wiring.
• All these steps must be carried out by a qualified tradesperson.
• If the heater cannot be adjusted to operate in accordance with these instructions, then contact the Brivis Customer
Service Centre (contact details are on the back cover of this manual).
14.1 StarPro Max/Plus & B-Max Heater Control Settings
The heater module has 3 push buttons. On the right is a SET button and on the left are the UP and DOWN buttons.
• To change an installer set-up parameter, press and quickly release the SET button, the word “SET” should now
appear on the top line of the screen.
• The UP and DOWN buttons may now be used to increase or decrease the value on any setting displayed on the
screen.
• By pressing the SET button the display will cycle through the installer set-up parameters in the order on the
following page.
19
Brivis Manual
Thermostat
Note: Only use alkaline batteries in a manual Thermostat. Other types can cause unwanted operation of the
heater when the batteries reach the end of their life.
W
R
W
R
To Next Page
Loading...
Need help?
General
