8
4 Digit
Code
Code Word
Reset Key
Message repeating
Push the FUNCTION button then Key 1 immediately after to repeat a message. Note: If no message repeats it means
either the button combination was incorrect or the event has passed. Typical messages displayed advise of some
appliance operations such as - “Pre-Wetting cooler pads - Please Wait!”
Coded Messages
While the Brivis Networker is operating your system, it is also monitoring and controlling every aspect of the system's
performance. If anything unusual occurs, the Brivis Networker will display an error message.
• A message stating "Cooler Fault - E01 Code #?? For assistance call 1300 BRIVIS" will scroll across the top
of the screen. Note: The message will vary depending on the problem.
• Whenever such a message appears, it is a good idea to write it down before doing anything el
se. This code
contains information that will enable Brivis to deal quickly and easily with anything that requires their
attention. With many of them you will be asked to contact Brivis Service and pass on the message, the
model and the type of appliance.
Service Notification Message
When the operating hours logged for an applaince exceeds the predetermined period, the Networker wall control displays
the following messages:
For Australia:
“Fan run hours indicate it is time for a service call - For assistance call 1300 Brivis”
For New Zealand:
“Fan run hours indicate it is time for a service call - For assistance call 0800 427 484”
The Spanner Icon will flash once every second on the Networker wall control display. You may book a service call or clear
the spanner icon notification by pressing
Key “4” on the Master Controller.
Resetting
If something has interrupted the units operation, the word Reset may appear beside Key 4 while a message is scrolling. Press
Key 4 to re-start the Cooler. If the Cooler does not resume normal operation, or the error message re-appears,
contact Brivis Service. If the Cooler is still operating but the Brivis Networker is showing an error message try pushing
the Reset Key 4 to clear the fault. If the fault persists contact Brivis Service. If the Cooler is not operating and any
other error message appears, contact Brivis Service.
Locking the Brivis Networker
To prevent any unwanted alterations being made to the coolers settings, the Brivis Networker can be locked via a 4-
digit PIN number. In the case of dual Brivis Networkers, if one is locked the other is also locked. If dual Brivis
Networkers are installed, the user pin numbers can only be set at the Master Brivis Networker. The Slave Brivis
Networker can only lock and unlock the system and cannot access the pin numbers.
To Next Page
Loading...
Need help?
General
