14
Troubleshooting continued
Problem Action
The unit will not turn on Check the circuit breaker has not been tripped - if so reset it.
Reset the Cooler at the power supply.
The unit is blowing warm air Check the water supply tap is turned on at the unit.
Check the pump has been selected on the wall control.
An error message is appearing Refer to the section on ‘Coded Messages’ and follow the checks.
on the B
rivis N
etworker Check the power point is plugged in and turned on to the Cooler.
The Brivis Networker display Check there is power to the power point with another appliance.
is blank Check the circuit breaker has not been tripped - if so reset it.
The unit is not cooling very well Check the water supply tap is turned on at the Cooler. Check the pump has
been selected on the wall control. Check sufficien
t door and/or windows have
been opened. Refer to Exhaust s
ection.
There is no air coming Contact our service department to place a service call.
out of some vents
There is moisture on my tiles Check the vents are directing air flow across the ceiling and not towards
the floor. If it is humid turn the pump off. Check sufficient door and/or windows
have been opened. Refer to Exhaust section.
The padlock
i
s appearing This indicates that the child proof lock has been activated.
on the screen Refer to the section on ‘Unlocking the Brivis Networker’.
For Your Records
Model Number: Serial Number: Install Date:
Installed by:
Installer Contact:
Service Records
To arrange a visit from one of our certified technicians please contact the Brivis Service department on 1300 BRIVIS
Service Provider: Contact Number:
Service Year 2
Service Date:
/ /
Service Year 4
Service Date:
/ /
Service Year 6
Service Date:
/ /
Service Year 8
Service Date:
/ /
Service Year 10
Service Date:
/ /
To Next Page
Loading...
Need help?
General
