Need help?Do you have a question about the Brivis SP630EN and is the answer not in the manual?
Procedures for installing internal models in roof spaces or beneath floors.
Instructions for installing flues for SP5, SP6, and SP4 internal models.
Procedures for internal installation of SP4 models, including splitting and pop orientation.
Procedures for external installation of SP4 models, including flue terminal.
Proper installation of the remote thermistor assembly for accurate temperature control.
Guidelines for draining condensate from SP6 models to prevent damage.
Proper placement and general wiring of Brivis thermostats for optimal control.
Connecting the Brivis Networker to StarPro heaters.
Adjusting installer set-up parameters on the heater module.
Procedures for initial ignition, gas checks, and fan/temperature settings.
Procedures for installing internal models in roof spaces or beneath floors.
Instructions for installing flues for SP5, SP6, and SP4 internal models.
Procedures for internal installation of SP4 models, including splitting and pop orientation.
Procedures for external installation of SP4 models, including flue terminal.
Proper installation of the remote thermistor assembly for accurate temperature control.
Guidelines for draining condensate from SP6 models to prevent damage.
Proper placement and general wiring of Brivis thermostats for optimal control.
Connecting the Brivis Networker to StarPro heaters.
Adjusting installer set-up parameters on the heater module.
Procedures for initial ignition, gas checks, and fan/temperature settings.
General| Model | SP630EN |
|---|---|
| Control | Electronic |
| Gas Type | Natural Gas |
| Ignition Type | Electronic Ignition |
| Electrical Rating | 230-240V, 50Hz |
| Heat Output | 6.3kW |
| Thermostat | Built-in |
To Next Page