Need help?Do you have a question about the Brivis SP623EN and is the answer not in the manual?
Connect gas piping per AS 5601 and local codes, including a gas cock for safety.
Connect to a 10 Amp 220-240V outlet via a qualified electrician per local regulations.
Install internal models in roof or underfloor spaces, following AS 5601 guidelines.
Ensure adequate room ventilation based on unit rating and volume per AS 5601.
Install external models on level bases, ensuring drainage and AS 5601 compliance.
Outlines required service clearances for various installation methods for SP5/SP6 internal.
General and specific instructions for flueing SP4, SP5, and SP6 internal StarPro series models.
Specifies minimum clearances required for front, back, end, and top of external heaters.
Guide for wiring the Brivis Networker thermostat to StarPro heaters.
Instructions for wiring programmable and manual Brivis thermostats.
Connect gas piping per AS 5601 and local codes, including a gas cock for safety.
Connect to a 10 Amp 220-240V outlet via a qualified electrician per local regulations.
Install internal models in roof or underfloor spaces, following AS 5601 guidelines.
Ensure adequate room ventilation based on unit rating and volume per AS 5601.
Install external models on level bases, ensuring drainage and AS 5601 compliance.
Outlines required service clearances for various installation methods for SP5/SP6 internal.
General and specific instructions for flueing SP4, SP5, and SP6 internal StarPro series models.
Specifies minimum clearances required for front, back, end, and top of external heaters.
Guide for wiring the Brivis Networker thermostat to StarPro heaters.
Instructions for wiring programmable and manual Brivis thermostats.
General| Category | Gas Heater |
|---|---|
| Model | SP623EN |
| Gas Type | Natural Gas |
| Ignition Type | Electronic |
| Control Options | Wall Controller |
To Next Page