BRIVIS CALL CENTRE WALL CONTROL MANUAL 601 ISSUE 1
28
PROGRAMMABLE TH4110
PROGRAM SCHEDULE
You can program four time periods each day, with different settings for
weekdays and weekends.
The
WAKE
setting is used to start the system and pre-warm the house before
everyone gets up.
The
LEAVE
setting can turn it off when the family has left for the day.
RETURN
is then used to switch the system back on again just before everyone
gets home.
SLEEP
can turn it off after they are all asleep.
A
DJUSTING THE PROGRAM SCHEDULE
• Press
SET
until set schedule is displayed.
• Press the
UP
and
DOWN
arrows to set your weekday wake time (Mon –
Fri), then press
SET
.
• Press the
UP
and
DOWN
arrows to set the temperature for this time
period, then press
SET
.
• Set the time and temperature for the next time period (leave). Repeat
steps 2 and 3 for each weekday time period.
• Press
SET
to set the weekend time periods (Sat – Sun).
• Press
RUN
to save and exit.
Note: make sure the thermostat is set to the system you want to use. (heat or
cool)
Note: to cancel an unwanted time period (except wake), press and hold the up
arrow for 4 seconds while in set schedule mode.
To Next Page
Loading...
Need help?
General
