Symantec
™
Endpoint Detection and Response 4.5 Installation Guide for the S550
appliance
You can use the management port for any of the following:
•
To access the EDR appliance console.
•
For communication to Symantec's servers (e.g., LiveUpdate, cloud-based sandboxing, Insight, telemetry, etc.).
•
To facilitate communication to SEPM and endpoints for the endpoint proxy.
The management network should not be open to the Internet as a whole. If you need access to the management network
from outside, a VPN or short-lived Remote Desktop connection is recommended.
In Inline mode, the management port must be on a different subnet from the Inline interface.
The following figures show examples of network configurations.
You might need crossover cables for Inline deployment if devices connected to WAN port and LAN port don't have
automatic MDI/MDI-X configuration.
16
To Next Page
Loading...