Broadcom Symantec S550 - Running Bootstrap; Running Bootstrap to Configure the Appliance

Symantec
™
Endpoint Detection and Response 4.5 Installation Guide for the S550
appliance
Running bootstrap
Running bootstrap to configure the appliance
You'll need to open the console window to run bootstrap.
During bootstrap, you are prompted to provide appliance configuration information. Your Symantec EDR administrator
provides you this information on the Installation worksheet.
When bootstrap is complete, the system restarts.
You can re-run bootstrap (for example, to change certain IP addresses) after initial installation from the CLI using the
bootstrap command. You cannot re-run bootstrap to change the operating role of the appliance.
1. In the console window at the login prompt, log in as follows:
User name = admin
Password = symantec
Bootstrap begins automatically when you are logged on for the first time before configuration.
Once you complete configuration, you can run bootstrap again using the bootstrap CLI command.
2. For each prompt, type a response and then press Enter to specify the required information.
The following table describes the bootstrap prompts:
New password: Type a new, secure password for the console. This password
replaces the default password, symantec.
Weak password
Try another [y/n]?
A password that is similar to a word in the Dictionary, is too
short, or not complex enough is less secure. Type y to
delete the new password and be prompted to try again. Type
n to keep the new password you previously entered.
Re-enter new password: To confirm the new password, type it again and press
Enter. If the two passwords do not match, you are
prompted to type and retype the password again.
Select one of the following appliance roles:
1 = Management platform ..., 2 = Network scanner ..., 3 = All-in-
one ... []?
Type the number that corresponds to the role for this
appliance. The prompt describes each of the roles available.
Configure the management port. IPv4 address []: Type a static IP for the management port. For a management
platform or all-in-one appliance, this IP address is used to
access the EDR appliance console from a browser.
IPv4 netmask []: Type the network mask for the management port IPv4
address.
Gateway []: Type the IP address for the gateway (switch or router) that
the appliance can use to communicate with the rest of your
network.
33