Broadcom Symantec S550 - Obtaining a Symantec EDR License File and Installing It

Symantec
™
Endpoint Detection and Response 4.5 Installation Guide for the S550
appliance
Table 9: Platform support matrix
Platform Config Specs ECC 1.0
ECC 2.0
Default
Events¹
ECC 2.0
All Events
Scanner Only
Throughput
Tap Mode
Scanner Only
Throughput
Inline Mode
S550 Default
configuration
18 Cores
Memory:
192GB
Hard drive:
4,158 GB
100,000
endpoints
100,000
endpoints
50,000
endpoints
n/a n/a
¹ Process Launch and Process Terminate events disabled.
² Symantec does not recommend inline mode for the virtual appliance. When you deploy a virtual appliance in inline mode
you run a risk because there is no bypass ability.
Obtaining a Symantec EDR license file and installing it
When you purchase Symantec EDR, Broadcom sends you a fulfillment confirmation "Welcome" email that includes your
serial number and a license key file attachment.
If you did not receive a Broadcom Welcome letter or you cannot locate your license key file, click here to go to the
Broadcom web site where you can access your license key file.
Save your license key file to a location that you can access from the EDR appliance console.
Install the license key file in EDR appliance console for product activation.
1. In the EDR appliance console, click Settings > Global.
2. Scroll down to the Licensing section and click Upload License.
3. In the Upload License dialog box, browse to and select the license file, and then click Upload.
The new license takes effect immediately, although it must be distributed to each of the scanners. If the previous
license had expired, make sure that you enable scanning again on all scanner devices.
Related Links
Symantec to Broadcom Transition Guide - My Entitlements
24