EasyManua.ls Logo

Broan QP330SS - User Manual

Broan QP330SS
28 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
BR N
QP3 SERIES
EVOLUTION TM 3
l Register your product online
at: www.broan.com
Page 1
WARNING
FOR DOMESTIC
TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR IN=
JURY TO PERSONS, OBSERVE THE FOLLOWING:
1. Use this unit only inthe manner intended by the manufacturer.
If you have questions, contact the manufacturer at the ad-
dress or telephone number listed in the warranty.
2. Before servicing or cleaning unit, switch power off at service
panel and lock the service disconnecting means to prevent
power from being switched on accidentally. When the service
disconnecting means cannot be locked, securely fasten a
prominent warning device, such as a tag, to the service panel.
3. Installation work and electrical wiring must be done by a qual-
ified person(s) in accordance with all applicable codes and
standards, including fire-rated construction.
4. Sufficient air is needed for proper combustion and exhaust-
ing of gases through the flue (chimney) of fuel burning equip-
ment to prevent backdrafting. Follow the heating equipment
manufacturer's guideline and safety standards such as those
published by the National Fire Protection Association (NFPA),
and the American Society of Heating, Refrigeration and Air
Conditioning Engineers (ASHRAE), and the local code au-
thorities.
5. This product may have sharp edges. Be careful to avoid cuts
and abrasions during installation and cleaning.
6. When cutting or drilling into wall or ceiling, do not damage
electrical wiring and other hidden utilities.
7. Ducted fans must always be vented to the outdoors.
8. Use only metal ductwork.
9. Do not use this fan with any solid-state speed control device.
10.As an alternative, this product may be installed with the UL-
approved cord kit designated for the product, following in-
structions packed with the cord kit.
11.This unit must be grounded.
TO REDUCE THE RISK OFA RANGETOP GREASE FIRE:
1. Never leave surface units unattended at high settings.
Boilovers cause smoking and greasy spillovers that may ig-
nite. Heat oils slowly on low or medium settings.
2. Always turn hood ON when cooking at high heat or when
flamb6ing food (i.e. Cr_pes Suzette, Cherries Jubilee, Pep-
percorn Beef Flamb6).
3. Clean ventilating fans frequently. Grease should not be al-
lowed to accumulate on fan or filter.
4. Use proper pan size. Always use cookware appropriate for the
size of the surface element.
TO REDUCE THE RISK OF INJURY TO PERSONS IN THE
EVENT OF A RANGE TOP GREASE FIRE, OBSERVE THE
FOLLOWING:*
1. SMOTHER FLAMES with a close-fitting lid, cookie sheet, or
metal tray, then turn off the burner. BE CAREFUL TO PRE-
VENT BURNS. If the flames do not go out immediately,
EVACUATE AND CALLTHE FIRE DEPARTMENT.
2. NEVER PICK UP A FLAMING PAN --You may be burned or
spread the fire.
3. DO NOT USE WATER, including wet dishcloths or towels - a
violent steam explosion will result.
4. Use an extinguisher ONLY if:
A. You know you have a Class ABC extinguisher, and you
already know how to operate it.
B. The fire is small and contained in the area where it started.
C. The fire department is being called.
D. You can fight the fire with your back to an exit.
* Based on "Kitchen Firesafety Tips" published by NFPA.
CAUTION
1. For indoor use only.
2. For general ventilating use only. Do not use to exhaust haz-
ardous or explosive materials and vapors.
3. To avoid motor bearing damage and noisy and/or unbal-
anced impeller, keep drywall spray, construction dust, etc.,
off power unit.
4. Do not use over cooking equipment greater than 60,000
BTU/hr. as the blower motor will shut down intermittently.
5. Your hood motor has a thermal overload which will automati-
cally shut off the motor if it becomes overheated. The motor
will restart when it cools down. If the motor continues to shut
off and restart, have the hood serviced.
6. The top of the hood MUST NOT BE LESS than 24" and at a
maximum of 30" above cooktop for best capture of cooking
impurities.
7. This hood is not intended to be used as a shelf.
8. Please read specification label on product for further infor-
mation and requirements.
[_lf hood is to be installed non-ducted:
Purchase a set of (2) non-ducted filters for 30" wide
hoods (Model BPPF30) & 36" wide hoods (Model
BPPF36) or a set of (3) non-ducted filters for 42" wide
hoods (Model BPPF42) from your local distributor or
retailer and attach them to the aluminum mesh filters.
Installer: Leave this manual
with the homeowner.
Homeowner: Cleaning, Maintenance and
Operating instructions on pages 2-4.
Question and Answer IconNeed help?

Do you have a question about the Broan QP330SS and is the answer not in the manual?

Summary

General Safety Warnings

Fire, Shock, and Injury Prevention

Instructions to reduce risks of fire, electric shock, or injury to persons during operation.

Grease Fire Prevention

Guidelines to prevent range top grease fires, including monitoring cooking and cleaning.

Grease Fire Injury Prevention

Steps to take to prevent injury to persons in case of a range top grease fire.

Hood Operation

Heat Sentry System

Heat Sentry System Operation (Fan On)

How the Heat Sentry system adjusts fan speed when the fan is on and temp rises.

Heat Sentry System Operation (Fan Off)

How the Heat Sentry system turns on the fan when temp is above normal while fan is off.

Light Bulb Replacement

Prepare Hood Location for Installation

Install Ductwork (Ducted Hoods)

Measure Installation Parameters

Minimum Mounting Height

Specifies the minimum required distance between the hood and the cooking surface.

Prepare Hood for Installation

Non-Ducted Installation Steps

Attach Non-Duct Diverter

How to attach the non-duct diverter to the air box using screws and washers.

Remove Non-Duct Plate

Steps to remove the non-duct plate from the non-duct plenum.

Install Non-Duct Plate

How to insert and attach the non-duct plate into the non-duct plenum.

Install Non-Ducted Filters

Instructions for purchasing and attaching non-ducted filters.

Ducted Installation Steps

Remove Knockout Plates

How to remove the appropriate knockout plate for ducting.

Attach Damper;Duct Connector

How to attach the damper/duct connector or round duct plate.

Install the Hood Unit

Electrical Shock Hazard Warning

Warning to switch off power at the service panel before installation.

Connect the Wiring

Broan QP330SS Specifications

General IconGeneral
BrandBroan
ModelQP330SS
CategoryVentilation Hood
LanguageEnglish

Related product manuals