Bron COUCKE MANDOLINE - Security; Using the Stainless Steel Hand Guard; Using the Polycarbonate Hand Guard; Cleaning and Maintenance

9
3 - SECURITY
> Using the stainless steel hand guard
Lower the main plate to the desired thickness.
Place the hand guard on its rails making sure the arrow on its handle is pointing
down the ramp.
Place your vegetable in the hand guard’s
hopper and begin slicing.
Push regularly on the top of the hand guard
in order to pressure the vegetable against the
plate.
> Using the polycarbonate hand guard
The safety guard can and should be used on all cuts. Place the vegetable to bec ut
against the guard’s stainless steel spikes to help hold it securely in place. Position
the guard at the top of the mandoline with its cutout arrows pointing up and down,
and slice the vegetable by moving the guard (and vegetable) up and down the man-
doline.
4/5 - CLEANING AND MAINTENANCE
Disengage the set of cutters, lower the fluted blade, and drop the main plate even
with the central cutter. Hold the Mandoline firmly and rinse and clean under warm
water with a bristle-type scrub brush. Be sure to remove any large pieces in the set
of cutters with the brush. Your Bron Mandoline is dishwasher safe.However, frequent
cleaning this way can contribute to the dulling of the cutting edges.From time to time,
check the tightness of the nuts.
6 - SPARE PARTS
Use the guard each time as possible in order to avoid any damage
(blades are very well sharpened)
A washing with hot water before the first use is recommended.
A washing after each first use is necessary and ensures a heal
-
thy equipment.
ENGLISH
7
Circular edge
6
4 Ref. 126CL - Fluted cutting plate
1
8 Ref. 136CL - Simple side
1
9 Ref. 137CL - Handle side
8
Ref. 146CL - Main plate
1
Ref. 166CL - Folding stand
3
Ref. 176CL - Straight blade
1
0 Ref. 183CL - Crank handle
2
Ref. 190CL - Non skid foot
Ref. 196CL - Set of screws
1
3
Ref. 19638 - Set of cutters
38 blades (3/8” and 1/8”)
1
4
Ref. 10644 - Set of cutters
44 blades (1/4” and 1/8”)
15 Ref. 11660 - Set of cutters
60 blades (3/16” and 1/12”)
1
6
Ref. 303CH - Plastic handle
for stainless steel guard
1
7
Ref. 304CH - Wooden handle for
stainless steel guard
6
Ref. 30300 - Stainless steel guard
7
Ref. 10201 - Polycarbonate
hand guard
Articulation