BROOD Nitro V2PX - General Information; Use; Viscosity of Liquid; Beverage container

BROOD Nitro V2PX Operations Manual V2.2 Eng
3
parts must be obtained from your service provider. Follow the service and maintenance instructions in
this operation manual.
2. General Information
2.1 Use
The Nitro V2PX pulls any filtered liquid from a pressurized or unpressurized container. It chills the
liquid to 2°C. It infuses the liquid with atmospheric nitrogen.
2.2 Viscosity of Liquid
Ensure that your beverage has been filtered in order not to clog the precautionary pre-filter or if
that has been bypassed, not to clog the machine. Thick liquids risk slowing down the liquid pump
inside the Nitro Coffee machine. The Nitro V2PX comes with a pre-filter that is already fitted into
the intake tube. If the pre-filter is not attached you can risk damaging components inside the Nitro
Coffee system.
2.3 Beverage container
Any non-pressurized or pressurized container can be used depending on what is required. We
recommend using a BiB that comes with the Nitro V2PX. Every machine comes with 3 BiB bags and
1 BiB Adaptor.
2.4 Specifications
Power Supply
115 V / 60 Hz; 230 V / 50 Hz
Dimensions (W/H/L)
210/357/425 mm
Weight
24.0 kg
Dispense flowrate
36 L/hr
Coffee temperature at tap*
2°C (+/- 1°C)
Internal tubing capacity
750 mL
Accessories
BiB Adaptor
Warranty
1 year
3. Setup
3.1 Assembly
The Nitro V2PX is delivered with the following parts:
Make sure the intake tube is pushed very firmly into both sides of the pre-filter to prevent air bubbles
from entering the tube.