BROOD Nitro V2PX Operations Manual V2.2 Eng
5
3.4 Nitrogen Control
Locate the Nitrogen control knob in the control panel at the side of the machine. Pull it outwards
gently until it clicks out of place. Turn it towards the minus (-) sign to decrease the nitrogen and
towards the plus (+) to increase nitrogen. Push it gently until it clicks in place. Keep it between 0
for no Nitrogen and 2. The factory setting is at the recommended level at 1. If the gauge is over 2,
then it risks too many large bubbles in your Nitro beverage.
4. Storing
Before putting the Nitro V2PX out of service for a period longer than 2 weeks, we recommend a
thorough flush with an espresso cleaner. Follow the cleaning steps below.
Store the Nitro V2PX in a
dust free environment between 2 C and 37 C.
5. Cleaning
The Nitro V2PX needs to be flushed with water every 24 hours. In addition, it must be cleaned every
14 days as described in the steps below. If it has not been used for a long period of time we recommend
cleaning it with a suitable espresso detergent.
1. Flush the Nitro Coffee machine with water every 24 hours. To do so, fill an empty bag with
clean water. Attach your Bag in Box Adaptor to the bag. Pull the tap so the Nitro Coffee
machine pulls the water and cleanses the machine.
2. For your cleaning cycle every 14 days please follow the remaining steps below.
3. Unscrew the stout and rinse it with fresh water. Screw it back on the tap.
4. Disconnect the pre-filter and unscrew it for inspection. Use tools if necessary as it is tightly
screwed. Clean the internal net and then reattach the cap. Reattach the pre-filter to the intake
tube. Make sure the tubes are firmly inserted.
5. Prepare a suitable espresso detergent in a jug. Dilute with room temperature water. Either fill
a bag with the espresso detergent solution and attach the BiB Adaptor; or fill an empty jug
with the espresso detergent solution, de-attach the BiB Adaptor, and drop the loose end of the
intake tube in the jug.
6. Pull the tap and allow the Nitro Coffee machine to draw the solution through the tubes until it
starts flowing from the tap. Follow the detergent manufacturer’s recommendations.
To Next Page
Loading...