oPeRaTIon
CHARGING THE WINE OPENER
1. Plug one end of the ADAPTER cord into the front of the CHARGING
BASE and the other end into an outlet.
2. Place the Wine Opener on the CHARGING BASE, ensuring that it’s firmly
in position and fully engaged with the charging connectors. The LED LIGHT
will illuminate while the unit is charging. It will take approximately 6-8 hours
to charge.
3. The Wine Opener will open approximately 50 bottles on a full charge.
IMPORTANT: The LED LIGHT must illuminate to ensure the unit is
charging correctly.
USING THE WINE OPENER
1. Before using the Wine Opener,
you must remove any foil from
the top of the bottle. Just place
the built-in FOIL CUTTER in the
top of the MAIN UNIT over the
top of the wine bottle and twist.
See the illustration on the right
for example.
6
672451_INS_Automatic Wine Opener V2
Instructions Doc. Size: 5”W x 4.75”H
Output at 100% Prints 1/0 Black
To Next Page
Loading...
