Brookstone “Bob” - Selecting 12- or 24-Hour Mode; Setting the Date

8
selectIng 12- or 24-hour mode
While in the Time screen, press or to select either 12- or 24-hour mode.
If 12-hour mode is selected, PM displays for the afternoon/evening hours.
AM does not display for the morning hours.
settIng the date
1. Remove the CLOCK BOTTOM and slide MODE LOCK ON/OFF to the
“On” position.
2. Press MODE until the Date screen displays. The orange LED backlight
illuminates for approximately four seconds.
3. Press and hold SET until the year starts blinking on the display.
4. Press
or incrementally until the correct year displays.
Or press and hold
or to move at a faster rate.
5. Press SET again. The month blinks on the display.
9
6. Press or incrementally until the correct month displays.
Or press and hold
or to move at a faster rate.
7. Press SET again. The day blinks on the display.
8. Press
or incrementally until the correct day displays.
Or press and hold
or to move at a faster rate.
9. Press SET again to save your date selection. The arrow at the bottom
of the display points to the corresponding day of the week.