OPERATION
BATTERY POWER/AC POWER MODE
Battery Power/Main Unit:
1. To install the batteries, open the BATTERY COMPARTMENT DOOR on
the back of the unit by sliding the door down per the arrow on the door.
2. Install 8 D batteries according to the polarity indicators inside the
compartment.
3. Close the BATTERY COMPARTMENT DOOR securely.
4. If using the unit in battery mode at this time, turn battery mode ON using
the BATTERY MODE ON/OFF switch on the back of the unit.
5. When the battery power is low, the POWER LED INDICATOR will flash
to alert you to change the batteries.
Battery Power/Remote:
1. Open the BATTERY COMPARTMENT tray on the side of the remote by
pushing the tab and sliding the battery tray out.
2. Install one CR2025 button cell battery according to the polarity indicator
inside the compartment.
3. Close the BATTERY COMPARTMENT tray securely.
AC Power:
1. Plug AC adapter (included) into DC jack on the back of the unit,
and then into an electrical outlet.
2. Turn battery mode to OFF using the BATTERY MODE ON/OFF switch
on the back of the unit.
Note: When the AC adapter is plugged into the unit, the battery power is bypassed
to save battery life—even if the BATTERY MODE ON/OFF switch is ON.
623405_INS_BoomBox for iPod
Size:5”Wx4.75”H_Output:100%_Prints:1/1,Blk
16
To Next Page
