Parts you may wipe with a damp cloth:
• Main body
• Chute
• Base
• Sensor
Note: DO NOT submerge the
MAIN BODY in water. DO NOT
fill the RESERVOIR with water.
REASSEMBLE
1. Make sure the SETTINGS KNOB is
turned to
.
2. Replace the AUGER BASE and secure
with the 2 AUGER BASE SCREWS.
3. Replace the AUGER. Make sure the
AUGER gear meets with the MOTOR gear.
4. Replace the AUGER COVER. Make sure
the AUGER cover opening is towards the
rear and covers the AUGER gear.
5. Replace the FUNNEL, making sure the
FUNNEL thumbscrew tabs and FUNNEL
opening are aligned with the MAIN BODY.
8
646570_INS_CandyMan
Size:5”Wx4.75”H_Output:100%_Prints:1/1,Blk
To Next Page
Loading...