Select > Cursor to End - Selects from the cursor position to the end of the
selected tracks.
Find Zero Crossings
- Modifies the selection slightly so that both the left and right
edge of the selection appear on a positive-slope zero crossing. This makes it easier
to cut and paste audio without resulting in an audible clicking sound.
Selection Save
- Remembers the current selection (or cursor position), allowing
you to restore it later.
Selection Restore
- Restores the cursor position to the last position saved by
“Selection Save.”
Move Cursor > to Track Start - Moves the cursor to the start of the current track.
Move Cursor > to Track End
- Moves the cursor to the end of the currently
selected track.
Move Cursor > to Selection Start
- Moves the cursor to the start of the
current selection.
Move Cursor > to Selection End
- Moves the cursor to the end of the
current selection.
Snap-To > Snap On - Enables “Snap-To” mode. When “Snap-To” mode is enabled,
the selection will be constrained to the nearest interval on the time scale, by default
the nearest second. So if you click and drag from 4.2 seconds to 9.8 seconds, it will
result in a selection from 4 seconds to 10 seconds, exactly. You can change the units
that are snapped to using the “Set Selection Format” option in the View Menu.
Snap-To > Snap Off
- Turns “Snap-To” mode off letting you select arbitrary
ranges of time.
Preferences - Opens the “Preferences” dialog.
24
To Next Page
Loading...