Brookstone iConvert USB Turntable - Page 37

TROUBLESHOOTING
PROBLEM CAUSE SOLUTION
The recording sounds
loud and distorted.
If your own USB device
is equipped with a Gain
knob, turn it down.
The USB device’s
Gain level is set
too high.
The USB device’s
Gain level is set
too low.
If your own USB device
is equipped with a Gain
knob, turn it up.
Computer audio
output not is
not set correctly.
Make sure that your
computer’s audio sound
card is selected as your
playback device. Please
note; depending upon
your computer, the
playback device will be
different but should not
say “USB Audio Codec.”
The recording
is barely audible.
I cannot hear my
recordings once
I have transferred
them and tried to play
them on my computer.
While the USB
device is connected,
I cannot listen to any
music from my computer.
Same as above.
Same as above.
36