POWER UP AND CONNECT
1. Slide the Power switch on the bottom of the Rover to on. The ORANGE
POWER LED will illuminate. Wait approximately 30 seconds and the BLUE
CONNECTION LED will start to blink slowly.
LED STATE CHART
2. On your iPod touch
®
, iPhone or iPad device, go to Settings and turn Wi-Fi on.
The SSID address of your Rover (17 digits starting with AC13_) will appear as
an available connection.
Note: Each Rover has a unique SSID address (printed on the underside of the
unit). If there are multiple Rover’s being used, the individual SSID addresses will
appear as Wi-Fi connections on your device. Select your Rover’s SSID address.
3. Select the Rover to confirm the connection. Ensure there is a check mark to the
left of the SSID address and the Wi-Fi connection logo appears at the top of
your device’s screen.
4. Exit out of Settings and open the Rover App.
5. The BLUE CONNECTION LED will now revert from blinking to solid.
6. When your device’s screen shows the view from the Rover’s live-stream video
camera—you are ready to start exploring.
11
LE tate Represents
Orange Solid Power on
Blue Blinking Searching for and acquiring Wi-Fi connection
Blue Solid Rover app is open and Wi-Fi is connected
D
S
To Next Page
Loading...
