Brose Allround - Display Modes and Settings

Operation and Control | Brose Display AllroundEN | 28
Switching off
To switch off the e-bike system you have the
following options:
› Press the «On/Off» key on the control unit
for at least 1.5 seconds.
› Switch off by pressing the «On/Off» key on
the e-bike battery (bicycle manufacturer-
specific solutions are possible that do
not have access to the battery «On/Off»
key, see battery/bicycle manufacturer‘s
manual).
» The system takes about 3 seconds to
completely switch off. You will not be
able to turn the system on again until it
has completely shut down.
NOTE
Control and display unit, drive unit and battery
are completely switched off.
If the e-bike drive power is not called up for
approx. 15 minutes (e.g. because the e-bike is
stationary) and no key is pressed on the e-bike
control unit, the e-bike system and thus the
battery will switch off automatically for energy
saving reasons.
The time in which the control unit goes to
«Shutdown Time» can be adjusted to your
needs at any time in the settings (refer to the
«Settings» chapter).
The control/ display unit is always switched
on; even if motor assistance is deactivated
(«OFF»).
Always turn off the Brose Drive System when
you stop the e-bike.
5.4. Display and Settings
5.4.1. Display
km
kmh
18
5
47.5
TRIP
(3)
(6)(4)
(2)
(1)
(5)
Fig. 2: Drive Mode
The display (Fig. 2) offers an overview of the
following information:
(1) System status information (e.g. faults)
(2) Lighting indicator
(3) Battery charge level indicator
(4) Display of current assistance
(5) Trip information (incl. unit)
(6) Speed (incl. unit)
The displays 1-3 form the status bar and are
displayed in the ride display on each screen.
With the «Menu» key you can also display
a range of information about your trip while
riding, so both hands can remain on the
handlebar while riding.
Use the «Plus» and «Minus» keys to increase
or decrease the assist level. If, for example,
you are in the settings menu, you can use
these keys to scroll up or down.
Bicycle lights
In the version in which the bike lights are
powered by the e-bike system, the front light
and the rear light can be switched on and off
simultaneously using the «Light» key (Fig. B-c)
on the control unit.