Intended Use | Brose Display AllroundEN | 24
NOTE
It is possible that Bluetooth® is not activated.
For further questions please contact an
authorised bicycle dealer.
ATTENTION
There is a risk of burns if the motor
housing is touched.
Under extreme conditions, e.g. sustained high
load at low speed when riding uphill or with a
load, temperatures >60°C can occur on some
parts of the drive.
NOTE
Make the basic settings on the control unit
before starting to ride. Unconcentrated riding
endangers you and other road users.
Familiarise yourself with the functions of the
e-bike and its operation before starting your
first journey.
Keep the user manual with you on all trips.
This will allow you to look up less frequently
needed functions at any time.
DATA PRIVACY: If the on-board computer is
sent to the service department for servicing,
the data stored on the device may be
transmitted to service employees.
2. Intended Use
The «Allround» display and control unit of the
Brose Drive System is intended exclusively for
use in this system. It serves to display ride-
relevant information and to control the drive
unit.
In addition to the functions shown here, it may be
that software changes for troubleshooting and
enhanced functions are introduced at any time.
3. Product Description
3.1. Brose Display Allround
The Brose displays ensure an optimal
interaction between cyclist and drive.
These new Brose control units are precisely
coordinated to the Brose Drive product family.
This allows the rider to enjoy a holistic e-bike
experience.
The functions are displayed on a 1.5 inch
colour screen. The convex screen can be
mounted flexibly on the right or left of the
handlebars and nestles seamlessly next to the
shifter or grip. Six specially emobossed control
buttons offer a sure feel and are ergonomically
positioned for optimum ease of use. For
optimal and quick readability, the selection of
data to be displayed can be set individually.
To Next Page
Loading...