200753_1 28
Operating the Stove - Remote Control Version
Paging the handset
If you have misplaced the handset you can page it by pressing the + button only on the
fire control for around 5 seconds. The handset will flash and make a noise to help you to
locate it. Once you pick up the TESC it knows you hold it and so the sound stops. The
flashing and sound will last for 60 seconds each time the handset is paged as described.
If not found in 60 seconds, page again and so on. NOTE: PRESS “+” Button ONLY, NOT
“+” and “-‘Together as you will accidentally break the handset pairing and have to reset
handset to factory state and pair again (see other parts of the booklet if this happens).
Installer note:
To reset the handset to factory conditions (to enable the handset to be paired
with another fire for example), hold handset to unlock, press and hold for at least
10 second the SET button. The green and red lights will start to flash. They will
flash for 1 minute and during this minute if you want to reset the handset, open
the battery box and remove a battery for a few seconds. Replace the battery and
cover, the handset will now be reset and ready to pair as a new handset to
another (or the same) device as shown above in pairing section.
Pairing a new handset
Remove the back panel and insert two AA Alkaline batteries in the direction
shown by the symbols moulded into the compartment and replace the cover.
Hold the handset with one hand ensuring your hand is wrapped around the back
and that your hand is in contact with both sides of the handset. The green light of
the “Unlock” symbol should light and flash. The flashing indicates that it is not
paired with anything at the moment and is ready to be paired. Put the handset
down within 1 metre of the Fire that you wish to pair the handset with. Press the +
and – buttons on the Fire Control (i.e. not the +and – buttons on this handset) for
around 6 seconds. The red light on the gas control will flash and then within 2
seconds press the power button on the fire control the handset should make a
noise and the green “Unlock” light should be flashing even without holding the
handset. The handset has received a pairing request and to accept this pick up
the handset and hold as described above to keep the keypad unlocked and press
and hold the “SET” button for 3 seconds. You will hear a beep and now the
handset is paired to the fire control. The unlock green light will stay permanently
lit when holding the handset Note: If the power button differently to the above i.e.
pressed for too long or too short a time or the grip on the handset is not firm or
released too soon, the Ignition will be interrupted and not complete. The reason
for the remote control having this strict start sequence is for safety reason so that
the starting operation of the fire will be most unlikely to be done other than
intentionally by an adult. If not done correctly, wait a few seconds and try again.
PLEASE EXPLAIN TO THE CUSTOMER THESE LIGHTING AND EXTINGUSIHING
PROCEDURES
To Next Page
Loading...
