Wireless configuration for Macintosh using the Brother installer application (MFC-9320CW only)
69
5
h Connect the Brother wireless device to your access point using a network cable and click Next.
i Choose the machine you wish to configure, and click Next. If the list is blank, check if the access point
and the printer are powered on, and then click Refresh.
Note
• The default Node name is “BRNxxxxxxxxxxxx”. (“xxxxxxxxxxxx” is your machine’s MAC Address /
Ethernet Address.)
• You can find your machine’s MAC Address / Ethernet Address by printing out the Network Configuration
List. See Printing the Network Configuration List on page 118.
To Next Page
Loading...
