Brother GT-541 - Warning Labels

9. Transporting GT-541
GT-541
263
(19) Remove the four Print Heads. (See “6-1-2. Replacing the Print Heads” for details.)
(20) Fit the Tube Joint 1 and 2 in the end of each of the disconnected Tubes.
(21) Attach the Nozzle Protect Film to each of the removed Print Heads.
* Cover the Nozzle surface of the Print Head with the Nozzle Protect Film. Put either end of the
Nozzle Protect Film between the Head Cover and the PCB Cover. Fix the other end of the
Nozzle Protect Film onto the Damper Case Support with adhesive tape etc.
Tub
e
Tube Joint 2
Head Cove
r
PCB Cove
r
Nozzle
Protect
Film
Damper
Case
Support
Tube Joint 1