29
Adjustment
Perform the operation while the printer is in Standby mode.
1) -> [Printer Setting] -> [CR Speed Adjustment] ->
[Start (after cleaning/setup)] -> (It takes about 3
minutes.)
2) When the printer stops with a sound and the printer returns
to Standby mode, the operation is completed.
1) Make sure that the platen height adjustment lever (a) is set
at the "A" position.
TIPS
Use a platen sized 14 in. x 16 in. (356 mm x 406
mm), which is included at the time of your
purchase.
Adjusting the carriage speed
1
Checking the nozzle check pattern
2
X0290
(a)
To Next Page
Loading...
