Step 3
• Mount the entire front section on the stand by lining
up the bolts with each of the support arms holes.
• Remember to install the triangle brackets here as
well for each side on the top.
• With the frame together make sure that each post
has a washer and nut. Then tighten all of them to
snug fit only. Do not overtighten or put excessive
pressure on them as this can cause a bolt to snap.
• With the frame now firm; flip the stand up and
install the waste tray on the left side of the stand.
• Lastly slide the board that came with the stand into
the support lips on the bottom section of stand
making a small table support.
4
To Next Page
Loading...
