Brother GTX600NB - Page 26

17
Setu
p
of the
p
rinte
r
Connect the humidifier water supply tube.
1.
Loosen the two screws on the lower left-hand-side cover on the
right-hand side of the printer.
2.
Remove the two screws and remove the cover.
3.
Insert the humidifier water supply tube into the outlet marked
WATER.
NOTE
Make sure to insert it to the end.
TIPS
Connectible tubes are those with an outer
diameter of 4 mm or 1/4 inch.
Install the removed cover, tighten the screws, and mount the
cap.
IMPORTANT
Be careful not to pinch the tubes.
*Remove this tube in the case
of using a tube with a connection
diameter of 4 mm.