CHAPTER 6 TROUBLESHOOTING
6-30
M-3 Main motor does not rotate
Possible cause
Step
Check Result
Remedy
Failure of
connector
1 Is the connection of connector
P9 on the engine PCB correct?
No Reconnect the connector.
Main motor 2 Is the problem solved by
replacing the main motor?
Yes Replace the main motor.
Engine PCB 3 Is the problem solved by
replacing the engine PCB?
Yes Replace the engine PCB.
Main PCB 4 Is the problem solved by
replacing the main PCB?
Yes Replace the main PCB.
M-4 No paper supplied
Possible cause
Step
Check Result
Remedy
Separation pad /
pick-up roller
failure
1 Is the surface of the separation
pad or the pick-up roller dirty or
worn out?
Yes 1) Clean the surface of the
separation pad or pick-up
roller.
2) Replace the separation pad
or pick-up roller.
Failure of
connector
2 Is the contact of the solenoid
connector on the engine PCB
good?
No Reconnect the connector.
Engine PCB
circuit
3 Set paper in the manual paper
slot and make a test print by
pressing the control panel
button.
Yes Replace the engine PCB.
Paper pick-up
clutch solenoid
Does the voltage between pins
2 (SOLENOID) and 1 (24V) of
the P13 connector on the
engine PCB change from
approx. 24V DC to 0V within
the specified time?
No Replace the paper pick-up
solenoid.
Main PCB 4 Is the problem solved by
replacing the main PCB?
Yes Replace the main PCB.
To Next Page
Loading...
