Brother HL-5030 - Page 128

HL-5030/5040/5050/5070N SERVICE MANUAL
4-31
NOTE:
When re-assembling the thermistor to the FU frame upper, ensure the direction of the
thermistor is correct referring to the figure below;
Fig. 4-53
(8) Remove the two cup B M3x20 Taptite screws.
(9) Remove the FU frame upper from the FU frame lower.
Fig. 4-54
Thermistor
Thermistor
Taptite, cup B M3x12
FU frame upper
FU frame lower
Hook
Hook
Pin
FU frame upper
Hook
Pin
Hook
Taptite, cup B M3x20
Taptite, cup B M3x20