3 - 8 CONTROL PANEL
Print a test page
You can use the Go button or the printer driver to print a test page.
Using control panel button
1
Turn off the printer.
2
Make sure that the front cover is closed and the power cord is plugged in.
3
Hold down the Go button as you turn on the power switch. All the LEDs light up and then go off
again. Keep the Go button pressed down until the Toner LED comes on. When the Toner LED
comes on, release the Go button.
4
Press the Go button again. The printer will print a test page.
Using the printer driver
If you are using Brother’s Windows
®
PCL printer driver, click the Print Test Page button. It is usually in
the General tab of the Windows
®
printer driver.
To Next Page
Loading...
