4
DO NOT put the product in a location that blocks or obstructs any slot or opening in the product.
These slots and openings are provided for ventilation. Blocking the product’s ventilation could
create a risk of overheating and/or fire.
• Keep a minimum gap around the product as shown in the illustration.
(HL only)
(MFC only)
• Place the product on a solid level surface.
• DO NOT place this product near or over a radiator or heater.
• DO NOT place this product in a “built-in” installation unless adequate ventilation is provided.
DO NOT place this product on an unstable cart, stand, or table. The product is heavy and may
fall, causing injury to you and serious damage to the product. For MFC products, there is an
added risk of injury if the scanner glass should break. Particularly, if you have children, please
make sure the product is located in a safe position.
150 mm
150 mm
150 mm 150 mm
300 mm
150 mm 150 mm 150 mm
To Next Page
Loading...
Need help?
General