CHAPTER 7 IBM PROPRINTER - 3
1. COMMAND LIST
NUL Null 8
BEL Bell 8
ESC Escape 8
SP Space 8
BS Backspace 8
LF Line Feed 8
FF Form Feed 8
CR Carriage return 8
Esc5n Automatic line feed 9
DC1 Enable printer 9
EscQ22 Disable printer 9
EscQ3 Disable printer 9
EscCRmode Reset printer / change emulation mode 9
EscCR!#R User reset 9
EscEMn Paper input control 10
EscCn Set page length 11
EscCNULn Set page length 11
EscXmn Set left and right margins 11
EscNn Set perforation skip 11
EscO Cancel perforation skip 11
Esc0 Set 1/8" line spacing 12
Esc1 Set 7/72" line spacing 12
EscAn Save n/72" line spacing 12
Esc2 Activate n/72" line spacing 12
Esc3n Set n/216" line feed 12
EscJn Execute n/216" line feed 12
EscDn1n2n3...NUL 13
Set horizontal tab stops
EscBn1n2n3...NUL 13
Set vertical tab stops
HT Horizontal tab 13
VT Vertical tab 13
EscR Restore default tab settings 13
Esc7 Select character set I 14
Esc6 Select character set II 14
DC2 Set pitch to 10 cpi 14
Esc: Set pitch to 12 cpi 14
EscPn Proportional spacing 14
SI Set condensed character mode 14
EscE Set emphasized character mode 14
EscF Cancel emphasized character mode 14
SO Set enlarged character mode for a single line 15
DC4 Cancel enlarged character mode 15
CAN Cancel 15
EscWn Enlarged character mode 15
EscSn Set superscript or subscript character mode 15
EscT Cancel superscript or subscript character mode 15
Esc-n Underline mode 16
Esc_n Continuous overline mode 16
Esc[@n1n2n3n4n5n6 16
Select double-height / double-width mode
Esc\n1n2<character data> 16
Select character from the All Character Code table
Esc^<char-code> Select a character from the All Character Code table 17
EscI Select character font 17
Esc=n1n220n3(n4n5<character definition data>...) 17
Define characters
To Next Page
Loading...
