APPENDIX B - FLASH/PCMCIA CARD COMMANDS - 15
3.7 Copy Card (For HL-1660e/2060/2400C/2400Ce/3400CN/2460/3260N/7050
/2600CN/3450CN Only)
Command
ESC CR ! 12357F
Available Devices
F, A
Description
1) Flash memory card
After executing a logical format on the transfer device, this command copies to the transfer device only when
the two devices have the same memory size. It is essential that the transfer device has already been formatted.
The specify device command allows you to specify the source device.
Specified Device Copy Order
1
Slot 2 Slot 1
2
Slot 1 Slot 2
** "Slot 2 Slot 1" is the default setting.
2) ATA flash memory card
After executing a logical format on the transfer device, this command copies to the transfer device file by file
from the master device.
If the memory runs short in the transfer device during the data transfer, the copy process is discontinued. Data
written to the transfer device before the error is valid in the device.
The specify device command allows you to specify the source device.
Specified Device Copy Order
1
Slot 2 Slot 1
2
Slot 1 Slot 2
** "Slot 2 Slot 1" is the default setting.
Error
43 CARD1 W ERROR
43 CARD2 W ERROR
(HL-2460 / 3260N / 7050)
Specified Device Copy Order
1
Internal HDD Slot 1
2,3
Slot 1 Internal HDD
Note that this command cannot copy the spool data.
Error
43 CARD ERROR
43 HDD ERROR
To Next Page
Loading...
