Unpack the machine and check the components
Toner Cartridge and Drum Unit
Assembly
AC Power Cord
Quick Setup Guide
Product Safety Guide
1
Remove the packing materials and install the toner cartridge and drum unit assembly
2
Load paper in the paper tray
3
Connect the power cord and
turn the machine on
Back Front
NOTE:
•The components included in the box may differ depending on your country.
•The available connection interfaces vary depending on the model.
If you use a wired connection, you must purchase the correct cable for the
interface you want to use.
•USB cable
We recommend using a USB 2.0 cable (Type A/B) that is no more than
2 metres long.
•Network cable (for wired network models only)
Use a straight-through Category 5 (or greater) twisted-pair cable.
•The screens and images in this Quick Setup Guide show the HL-L2460DW.
•Save all packing materials and the box in case you must ship your machine.
Remove the orange part.
1
2
Push firmly.
Adjust the paper
guides.
Do not exceed this mark.
Remove the protective tape or film covering the machine and the supplies.
4
Select your language (if needed)
1. Press▼or▲toselect[Initial Setup], and
then press OK.
2. Press▼or▲toselect[Local Language], and
then press OK.
3. Press▼or▲toselectyourlanguage,andthen
press OK.
Quick Setup Guide
Read the Product Safety Guidefirst,thenreadthisQuick Setup Guide for the correct installation procedure.
Not all models are available in all countries.
The latest manuals are available at the Brother support website:
support.brother.com/manuals
HL-L2400DW / HL-L2440DW / HL-L2445DW / HL-L2461DW / HL-L2460DN /
HL-L2461DN / HL-L2460DW / HL-L2460DWXL / HL-L2865DW
D02UUV001-00
OCE/ASA/GLF/TWN
Version 0
To Next Page
Need help?
General